-
Administrator
all the ones we tested would do 53 and hit 54 for a sec here and there new..added sheave and did 58 hit 59 for a sec here and there..spring would make it faster uphills and slower on flats usually if everything is working right...any speed with our sheave below 58 with stock tires has a worn belt for some reason or motor,gas ect issues...but it should hit the rev limiter at 58-59
-
Post Thanks / Like - 0 Thanks, 3 Likes, 0 Dislikes
-
Installed one last night with slugs gets up a little faster but topped out at 51 with 26" tires didn't really matter slightly down hill on pavement was still 51
Sent from my iPhone using Tapatalk
-
are you hitting the rev limiter?
2006 Rhino 660
686 Big bore, 11:1 comp, stage 1 cam
Elka stage 3 shocks
Power steering
Innovate AF gauge
Temp,Volt, and Fuel gauges
12" ITP beadlock wheels
26" ITP Terracross tires
Trail bright LED headlights
Trail bright 30" LED light bar
RZR seats with flat aluminum bases & 4 point harnesses
Dual battery set up with battery separator and 8 place fuse block
-
Administrator
purple or gold will help uphill speeds but lower the top end cause the rpms are set low
-
Administrator
something not right ..i will make vids of all the next ones i do
-
He's almost 10mph off, think he flopped one?
Sent from The Green Machine
-
Mine tops at 50 as well. I thought I would lose some of the top for the low end grunt? 17 gr and stock spring.
Bob
-
mine was topping out at 46 too. i have 28in. tires though and after confirming with timmi, who was behind me going wide open at 52mph my speedo was off that much just from the tires. sunday with me and the wife inside i hit 47 and bumped 48 which would give me 53/54 (im assuming) and im still not hitting the rev limiter!!
Sent from my iPhone using Tapatalk
CASPAR
2016 Yamaha Wolverine R-Spec (camo)
Yamaha roof, Yamaha folding windshield, Yamaha fender flares, Yamaha heavy duty front and rear bumpers, Yamaha toolbox, Yamaha vinyl rear window. JBS sheave and slug kit (18g sliders for now) 28x10x14 blackwater evolution tires on 14 inch MSA M26 dark tint vibe wheels, Superwinch 4,500lb winch, 2-32 inch light bars on front, light pods on pillars, 32 inch ligh bar on back, eagle eye backup lights, homemade led whips,
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
I was hitting rev limiter
Sent from my iPhone using Tapatalk
-
Do need a gold spring??
Well Iv had my new wovie for 8 months now and got about 450 miles on. It's absolutely nice to ride all day. And just goes any were. But I ride a lot of sand washes. And think I could use a little more kick in the mid range, powering out of the tight corners at about 25 mph to 50. So what do in need to get to get that mid range out of the hole shot power. Thanks guys.
Bookmarks