EMP a arm guard review.

[bob3663]

So here's my review.

I am a member on rzr forum so I got a 10% discount. With shipping total came to 185 for all 4 corners. Not bad at all. I live 2 hours away so I received them on Tuesday when they were shipped Monday. Very quick. They are on par with the ricochet ones I had one my popo 850 xp atv. Same style and quality. Half price. They are a bit superior in design imo, due to EMP cut holes and slots to allow drainage of mud and to wash out easier. This was always my complaint with others. They mount fairly easy, however the front plastic bash plate should be trimmed a touch. They do rub but it will only take one ride to wear it in and then be able to cut them as needed. The rear ones mount easy as well, but the clamps they gave me don't ait flat on skid like the ricochets. It does make it a bitch to get them tight without moving. They came with nylon nuts and tightening them makes it a bit challenging. The clamp wants to spin with bolt and nut. Altogether it took about 45 minutes to an hour to mount all 4 with the COLOR directions. Directions were straight forward and to the point. Which is nice. They did leave out the front factory CV gaurds need removed, but that is a no brainer really. All in all I'm very happy with these a arm guards. They look like they will take a beating and not be an issue. Fronts are held on with 3 bolts, while back is held on with 4. If you need or want a set, I would highly recommend them over Yamaha ones simply on price.

And they threw in a free coozie and sticker.

Bob

Sent from my XT1575 using Tapatalk

[WV Hot Rod Rhino]

looks good..3/16 thick?

[bob3663]

Yea. Website says nearly 3/16. But its close

Sent from my XT1575 using Tapatalk

[Tmcelheny]

They look sweet


Sent from my iPhone using Tapatalk