Ok, now to replace the 1/2" Heim's with 3/4" units. This part was a bit of a challenge as the tubing perimeter was not large enough to handle the Heim's. I also had to build pockets in the frame for them to fit, hence why Turnkey used the smaller 1/2" heim's.

Ends prepped for the new inserts. had to use the Plasma cutter to cut the resette welds out, talk about a pain.



Tapping the new inserts on the lathe. I made these out of solid 1 1/4" od 2018 I had in stock.



Milling the pocket flats



Inserts welded in. I ended up adding a filler channel to finish off the are where the insert is outside the tubing.