Door poll

[WV Hot Rod Rhino]

Getting ready for the cross braces.......

Sent from my Moto G Play using Tapatalk

[Timmi]

first one for sure

[jerhomey]

1st or 3rd

[GetemDuck]

i vote number 1

[Shawnh]

1st one

[buckg2]

Lol, I like number 2. Keeping the the top brace with the same angle of the lower plastic piece that says Yamaha

[Timmi]

Which assumes the door panel will be inside the frame.........

Lol, I like number 2. Keeping the the top brace with the same angle of the lower plastic piece that says Yamaha

[buckg2]

I would skin the outside

[walkntall]

I would make the skin to be able to go on either side if possible and then you have a win win for everyone. I would guess it would have to be cut a tad bigger to go on the outside but if you had 2 templets and cut out a stack of each then just attach them as needed to whichever side and keep 2 or 3 sets of each on stock and replenish as needed.

I think i would like them on the outside, since mine is the silver viking i would probably take a grinder with a wire wheel on it and put some of that brushed texture design on it.

[Yotehunter66]

#2. The angle of the door braces flows with the rest of the body slant.