Torque specs

[therebel19]

Do we have the torque specs for the primary and secondary nuts yet?

[therebel19]

Secondary is kind of a bear. I couldn't get it the spring to compress using the wheel and tire method and I'm 6'4 280lbs right now. I had to make my own spring compressor. The nut is a 54.5 mm or 2 and 9/64 if I read my tape tape measure correctly. Can't wait to try and put it all back together but I'm sure it will be worth it.

[Timmi]

I haven't found a service manual for the new wolverine.

[WV Hot Rod Rhino]

Secondary is kind of a bear. I couldn't get it the spring to compress using the wheel and tire method and I'm 6'4 280lbs right now. I had to make my own spring compressor. The nut is a 54.5 mm or 2 and 9/64 if I read my tape tape measure correctly. Can't wait to try and put it all back together but I'm sure it will be worth it.

I don't have secondary springs for the X 2 X 4 yet they are at eibach

Sent from my Moto E (4) Plus using Tapatalk

[therebel19]

Well that sucks. If you shipped my other parts, than I guess this was a learning experience for me if the springs are still a ways out.

[WV Hot Rod Rhino]

Other stuff has shipped

Sent from my Moto E (4) Plus using Tapatalk

[therebel19]

Good deal!

[therebel19]

Which way do the sheave sliders go back in. Do the raised marks go toward the cap or away from it?

[Timmi]

[therebel19]

Thanks Timmi I needed that too, but I meant the sliders that go on the cam plate.