-
Belt/ clutch burn smell after JBS install
Merry Christmas Everyone,
hello all, new to the site and to yamaha's. I've installed the clutch and slug kit, I am now getting a clutch and or belt burning smell after doing so, especially after hard acceleration. Any ideas on where I should start looking?
-
Administrator
Originally Posted by
hutch301
Merry Christmas Everyone,
hello all, new to the site and to yamaha's. I've installed the clutch and slug kit, I am now getting a clutch and or belt burning smell after doing so, especially after hard acceleration. Any ideas on where I should start looking?
Pinched o-ring or over grease
Sent from JBS test site
-
Administrator
Or if something was coming loose and the belt slipping because of it..post some pics when you tear into it
Sent from JBS test site
-
Originally Posted by
WV Hot Rod Rhino
Or if something was coming loose and the belt slipping because of it..post some pics when you tear into it
Sent from JBS test site
Thanks, I’ll start there and will get some pics as well. Appreciate it
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Too much grease?
The o-ring didn’t look pinched.
-
Administrator
Originally Posted by
hutch301
Too much grease?
The o-ring didn’t look pinched.
Grease looks right...new belt?
Sent from JBS test site
-
Originally Posted by
WV Hot Rod Rhino
Grease looks right...new belt?
Sent from JBS test site
No sir not a new belt.
-
maybe the washer wasn't up on the spines when the nut was tightened and gave it a little slop?
2015 Viking EPS SE
KFI Stealth 4500s
KFI 72" Open Trail Plow
SuperATV Flip Up Windshield
SuperATV Side Mirrors
Seizmik Soft Rear Window
IR Backup Camera
42" LED Light Bar
JBS Extreme Sheave
JBS Slug Kit
Black & Gray YXZ seats
JBS Doors
Lots More Planned...
-
Since you did not say, can we make assumption it is running good? is it making any chirping noises? Did you service the secondary? Is secondary shifting smoothly? Is there any grease on sheave faces (primary or secondary) from fingers?
2016 Wolverine R-Spec EPS, Camo, fender ext. 4000 Moto winch w/syn rope, 14"Method B-locks, 27" Maxxis Vipr 9 & 11's, Full flip windshield, A-arm guards, 2 batts, JBS CVT grind, 16 OD, slugs, purple, JBS/Eibach springs, Autometer Temp Gauge
08 Rhino 700 SE Black Armor, JBS 734 (bbk w/Carillo crank & rod, CP 11:1, deshrouded valves, Raptor springs, Viking cam & FI, MSD, afr Gauge, Unleashed sheave w/JBS OD 18g greased, Purple, slugs, 27" Mudlite XTRs , 6" Chopped , Mishi Rad, ALBA exhaust
Bookmarks